Figure 191 – Message Sequence View – between a single device and All others
Showing the Message
Sequence between a specific device and All others is accomplished by selecting
the desired single device in Network View and adding it to the Message Sequence
View through the right-click menu, or by selecting the device in Network View
and then dragging (from the drag-and-drop handle that appears after it is
selected - 
) and dropping it into the Message Sequence
View window.
Dragging and dropping a single selected message from Time View
or Message View to the Message Sequence View window (provided that the message
is transmitted form a specific device but without a specific destination address
– e.g. broadcast messages), results in adding the originating and destination
devices of the selected message to the Message Sequence View. If the destination
of the message is known, both the source and destination devices will be
added.
Devices included in the Message Sequence View can be removed from it
by right-clicking on the device section and selecting Remove Device
.
All the message sequence view can be
cleared by pressing on the ‘Delete all Elements’ icon in the Message Sequence
View toolbar.
Notes:
The
highest layer displayed as a vertical line appears only if the relevant messages
included in the Message Sequence View include that layer.
If a Device or
layer is set to be temporarily hidden from view (see paragraphs 3.2.10 and 6.6) its representing
vertical line/s will be shown using dash lines.