Pending on the Perytons™ Protocol Analyzer license type, different capture devices can be selected from the Dongle Type drop down list.
Note: Different types of dongles can’t be mixed in a single capture session.
Figure 214 – Choosing the Dongle Type
Currently the Perytons™ Protocol Analyzer supports the following capture devices:
•Dizic – 2.4GHz USB Dongle
•Telegesis – ETRX3USB 2.4GHz USB Dongle
•dresden elektronik deRFusb-23E00 USB Dongle
•STMicroelectronics STM32W-SK 2.4GHz USB Module
•Freescale MC1322x 2.4GHz USB Dongle
•Adaptive Modules - DAUB1-2400 2.4GHz USB Dongle
•Texas Instruments CC2531 2.4GHz USB Dongle
•Texas Instruments CC1111 SubGhz Generic USB Dongle
•Lapis (former OKI) Semiconductor 2.4GHz USB Dongle
•Adaptive Networks Solutions ANY 900 - 1 868/915MHz USB Dongle
•Adaptive Networks Solutions ANY 2400 USB Dongle
•Integration Associates (Silabs) DAUB1 2400 USB Dongle
•Telegesis ZigBee Communications Gateway (for capturing data from an IP connected remote location)
The list of supported USB
dongles gets constantly updated with additional front-ends that can connect to
the Perytons™ Protocol Analyzers for capturing data. It is strongly recommended
to check the Perytons™ site for an updated list of supported front-ends, drivers
and firmware.
Note: Due to limitation of the dongle manufacturers
or their firmware, not all front-ends can run with all the Perytons™ Protocol
Analyzers' models see
http://www.perytons.com/zigbee/support/supported-hardware.